Supportnet / Forum / Plauderecke
Reset für ar 220e
Frage
Hallo,
ich kann nicht mehr auf meinen Router zugreifen,und ich weiss nicht wie ich das ding resete.
Kann mir da mal jemand helfen ???
Antwort 1 von hundredandone
Question
How to reset the AT-AR220E to factory defaults when running v1.11 code? (lost password)
Answer
1. Remove all cables from the Router including the power supply cable.
2. Press the �Uplink� switch so that it is in the �In� position.
3. Connect one end of a straight through RJ45 cable to port 4 and the other end into port 1.
***This creates a loopback from port 4 to port 1
4. Re-insert the power supply cable and wait 5-10 seconds and then disconnect the power supply cable. If the
Self Test LED goes out before the 5-10 seconds that also is a way of showing that the process has completed
and you can disconnect the power supply cable then.
***During the 5-10 seconds you will see the Self Test LED blink orange and
the middle green Link/Act lights on port 1 and port 4 blink.
5. The Router is now reset back to factory defaults.
6. With the Router still powered OFF, re-connect one end of the RJ45 cable into port 1 and the other end into the
network adapter in the workstation.
7. Press the �Uplink� button into the �Out� position which is now in Normal.
8. Re-connect the power supply cable to the 220e.
9. Test the connection by typing 192.168.1.1 from your web browser.
How to reset the AT-AR220E to factory defaults when running v1.11 code? (lost password)
Answer
1. Remove all cables from the Router including the power supply cable.
2. Press the �Uplink� switch so that it is in the �In� position.
3. Connect one end of a straight through RJ45 cable to port 4 and the other end into port 1.
***This creates a loopback from port 4 to port 1
4. Re-insert the power supply cable and wait 5-10 seconds and then disconnect the power supply cable. If the
Self Test LED goes out before the 5-10 seconds that also is a way of showing that the process has completed
and you can disconnect the power supply cable then.
***During the 5-10 seconds you will see the Self Test LED blink orange and
the middle green Link/Act lights on port 1 and port 4 blink.
5. The Router is now reset back to factory defaults.
6. With the Router still powered OFF, re-connect one end of the RJ45 cable into port 1 and the other end into the
network adapter in the workstation.
7. Press the �Uplink� button into the �Out� position which is now in Normal.
8. Re-connect the power supply cable to the 220e.
9. Test the connection by typing 192.168.1.1 from your web browser.
Antwort 2 von hallogen
Antwort 3 von Greyhound
Hallo,
Danke für diesen Tip,mein Router funzt wieder.
Danke für diesen Tip,mein Router funzt wieder.
Antwort 4 von Greyhound
Hallo @ all !!!
Wenn da noch jemand Probleme mit seinem Router zwecks Ports freigabe hat sollte er mal hier vorbeischauen:
http://www.nuclearstrike.org/routerforum/
da steht allen genau beschrieben.
Gruss Greyhound & einen guten rutsch
ins Jahr 2007
Wenn da noch jemand Probleme mit seinem Router zwecks Ports freigabe hat sollte er mal hier vorbeischauen:
http://www.nuclearstrike.org/routerforum/
da steht allen genau beschrieben.
Gruss Greyhound & einen guten rutsch
ins Jahr 2007