Supportnet Computer
Planet of Tech

Supportnet / Forum / Peripherie

Problem mit COM-Port





Frage

Hallo, ich betreibe seit langer Zeit einen Programmer für PIC´s von Microchip am com-Port. Seit dem ich ein neues Motherboard habe funktioniert der Programmer nicht mehr. Der Programmer hat ein kleines Testprogramm für den com-Port integriert. Demnach geht es Daten zu senden aber nicht zu empfangen. Die Hilfe des Programmers schreibt zu dem Problem folgendes: "If the WARP-13 responds to the "Turn Vdd and Vpp on ISP port ON" by turning on the Vdd and Vpp volts to the ISP port but there are still other Comms problems, the two "PING" commands that will further aid in tracking down the problem. The first ping is "ping without handshake" and the purpose of this command is to see if the WARP-13 is able to both receive and transmit data without concern for the hardware handshaking. If the WARP-13 does not return a ping in response to this command (but responded to the above voltage command) then the RX line is not functioning. The RX line is between pin-2 and pin-2 on each of the 9-pin connectors (WARP-13, PC and cable) and the signal originates from pin-24 of the firmware chip. This signal is at 0-Volts and should pulse to around 4.5V when the ping command is received. If a signal is detected from this pin and continuity to the PC is verified then the problem is likely to be a software driver on the host PC "stealing" the serial byte sent. This type of problem typically happens when a MODEM has been installed on the same COM port and sometimes even when it is on another COM port. The presents of a modem or network is the common cause of comms errors." Ich bekomme das Ping-Signal nicht zurück. Soviel ich weiß habe ich kein on-Board-Modem, daß ich abschalten kann. Habe zumindest nicht´s im BIOS gefunden. Mein PC hängt über Netzwerk am DSL-Modem SE515. Was kann ich da machen um den Ser. Port zum laufen zu bringen? Ich habe folgendes Board: MSI K8N SLI mit einem Athlon 4400+, 2GB Speicher und WIN XP Pro. Konfiguration ser. Port: 19200 Baud, 8N1, keine Flußsteuerung. Mit Flußsteuerung läuft es auch nicht. Danke Klemm

Antwort von



Ich möchte kostenlos eine Frage an die Mitglieder stellen:


Ähnliche Themen:


Suche in allen vorhandenen Beiträgen: